|
Conditions of Sale
Medium Pressure Linear Lamp Warranty
High Pressure Air-Cooled Short Arc Lamp Warranty
High Pressure Liquid-Cooled Short Arc Lamp Warranty
Conditions of Sale
DeliveryShipping dates are approximate and are based on prompt receipt of all
necessary technical information. The company shall not be liable for delays in
delivery or failure to manufacture or deliver due to causes beyond its
reasonable control.
PricesAll
prices quoted are subject to change without notice. All orders will be
represented by prevailing prices in effect at time of shipment.
Sales and Similar Taxes
Unless specifically stated, the company's listed
price does not include sales, use, or similar taxes. Thus, any tax applicable to
the sale of an item shall be paid by the purchaser, or purchaser in lieu shall
furnish the company with a tax exempt certificate acceptable for tax
authorities.
Terms of Payment
All invoices are due and payable not
later than 30 days from date of invoice.
Back to Top
Medium Pressure Lamp Warranty
1. This lamp emits large amounts of ultraviolet radiation which can be
extremely harmful to eyes and skin. Great Care should be taken to insure that personnel are not
exposed to direct or reflected radiation from this lamp. Suitable eye and skin
protection must be employed when lamp is in operation.
2. This lamp generates ozone gas during operation. Operating equipment and work areas
should be adequately ventilated to comply with the OSHA regulations for ozone.
3. This lamp should be handled only when
cold and with clean cotton gloves. Alcohol can be used to remove finger prints
and all external foreign matter. Premature devitrification and dramatic poor
lamp performance are directly related to a clean outer surface.
4. This high intensity electric
discharge lamp will operate properly only if the auxiliary equipment conforms to
the physical, electrical, and thermal specifications established by the
manufacturer.
5. This lamp is warrantied for the
number of hours set forth below - providing the outer bulb surface does not
exceed 850ºC and the foil seal does not exceed 350ºC.
6. This warranty applies to the lamp
only and cannot be expanded or modified. This warranty being exressly in lieu of
all other warranties expressed or implied and of all other obligations or
liabilities on its part, the manufacturer neither assumes nor authorizes any
other persons to assume for it any other liability in connection with the sale,
operation, or failure of this lamp. This warranty does not apply to accidental
breakage, nor responsible for the costs involved during lamp replacement. All
shipping costs for replacement lamps are the responsibility of the customer.
*No lamp can be considered for Warranty unless
Warranty Card was mailed within 5 days of installation - ABSOLUTELY NO
EXCEPTIONS
Warranties do not cover the following
customer related responsibilities:
1. Any surface contamination or
devitrification ( The major source of any lamp failure).
2. Bowed lamps.
3. Poor lamp contactors indicating
discolored end fittings.
4. Distorted and overheated tubing and
overheated foil seals.
5. Normal lamp fall off does not
indicate lamp failure
6. Lead wires burned off. Maximum
allowable temperature is 200ºC.
7. Lamps idled at 120 W/I or lower for
excessive time. Due to high voltage and high current spikes. Plasma
cleaning will cause electrode, capacitor and mercury relay failure.
Superior Warranty
NOTE: For Lamps above 400 W/I - Consult factory for
warranty THIS WARRANTY IS RESTRICTED TO REPLACEMENT OF THE LAMP ONLY AND THE
MANUFACTURER SHALL NOT BE RESPONSIBLE FOR ANY OTHER DAMAGES, CONSEQUENTIAL OR
OTHERWISE.
ALL PLASMA DISCHARGE LAMPS HAVE
A NORMAL 365NM UV OUTPUT FALL OFF OF APPROXIMATELY 25% DURING THE FIRST 1000
HOURS OF LIFE AND DOES NOT INDICATE A MANUFACTURER DEFECT." Consideration of warranty adjustment will be given only after the
DEFECTIVE CLAIM FORM on the reverse side has been completed and returned to the
distributor. DO NOT RETURN THE LAMP UNTIL NOTIFIED.
Back to Top
|